15-5

Appendix E Setting DEFAULT GATEWAY at the Control Panel

1.Press On Line button on the Control Panel. Be sure the light next to it is OFF

2.Press Menu . The ON-LINEmessage disappears and TOP MENU is displayed.

3.Press Up+ until <COMMUNICATIONS> appears on the Display Panel and then press Enter.

4.Press Up+ until <NETWORK SETUP> is displayed and then pressEnter.

5.Press Up+ until <TCP/IP> is displayed and then pressEnter.

6.Press Up+ until <GATEWAY> is displayed and then pressEnter.

7.To set each digit of the subnet mask, pressUp+ to increase the digit value. Press Down- to decrease the digit value. When each digit is correct, pressNext button to move on to the next digit.

8.The Next button wraps around the display without setting the value if an error is made. After the complete IPaddress is displayed correctly, pressEnter. The Default Gateway address is now set.

9.Reset Printer to have the new settings take effect.

XPrint UNIX SYSTEM PRINTER DRIVER INSTALLATION

15-5

Page 49
Image 49
Xerox 701P91273 manual XPrint UNIX SYSTEM PRINTER DRIVER INSTALLATION, 15-5