Xerox xerox documate 3115 manual Scanner Configuration

Scanner Configuration

The scanner configuration tab shows the hardware information for your scanner.

Power adjustments:

•Power off—input the number of minutes you want the scanner to wait before it turns itself off. Click the green enter button to save any changes in the power off field.

Click the red reset button to reset to the default timeout value.

•Reset device—click this button to revert the scanner hardware back to the scanner’s firmware defaults. As this option resets the scanner hardware, you will not see a change in the interface unless the power save time has been changed. Clicking this button includes returning the power save time-out to the default setting.

•Enable the detection of excessive document skew—when selected, scanning will stop if the scanner detects that an item is being fed through at too great of an angle.

•Exit front-fed paper through the back—when selected, front-fed pages will exit from the back of the scanner. When this option is not selected, front-fed paper will exit from the front of the scanner.

•Calibrate—click the Calibrate button to start the scanner calibration wizard. The scanner self- calibrates when you click the Calibrate button. The calibration window on-screen will close automatically when calibration is finished. If it doesn’t close automatically, click the Finish button.

Scanner maintenance:

•Counters—click the reset button next to the counter you want to set back to 0.

You can use this option to monitor the number of scans completed since the last time a part has been replaced.

Xerox® DocuMate® 3115	185
User’s Guide