Samsung SCX-6555N Series manual System Requirements, Configuring network protocol via the machine

If you are in a non-static IP address environment and need to set up a DHCP network protocol, go to http://developer.apple.com/networking/ bonjour/download/, select the Bonjour program that is appropriate for your computer operating system and install the program. This program will allow you to set network parameters automatically. Follow the instructions in the installation window. This program does not support Linux.

Configuring network protocol via the machine

You can set up TCP/IP network parameters, follow the steps listed below.

1.Make sure your machine is connected to the network with an RJ-45 Ethernet cable.

2.Make sure you have turned on the machine.

3.Press Machine Setup on the control panel.

4.Press Admin Setting.

5.When the login message appears, enter password. Touch the password input area, then the question marks appears. Use the number keypad on the control panel to enter the password. Once the password is entered, press OK. (Factory setting:1111)

6.Press the Setup tab > Network Setup.

7.Select TCP/IP Protocol.

•Apple Talk Protocol: This protocol is widely used in Macintosh network environments.

•Ethernet Speed: You can select the communication speed for Ethernet connections.

8.Press IP Setting.

9.Select Static and then enter IP Address, Subnet Mask and Gateway address fields. Touch the input area then, enter addresses by number keypad on the control panel.

Contact the network administrator if you are not sure how to configure.

10.Press OK.

You can also set up the network settings through the network administration programs.

•SyncThru™ Web Admin Service: Web-based printer management solution for network administrators. SyncThru™ Web Admin Service provides you with an efficient way of managing network devices and lets you remotely monitor and troubleshoot network machines from any site with corporate internet access. Download this program from http:// solution.samsungprinter.com.

•SyncThru™ Web Service: Web server embedded on your network print server, which allows you to:

-Configure the network parameters necessary for the machine to connect to various network environments.

-Customize machine settings.

-Customize email settings and set up address book for scanning to email.

-Customize server settings and set up address book for scanning to the FTP or SMB servers.

-Customize printer, copy, and fax settings

•SetIP: Utility program allowing you to select a network interface and manually configure the IP addresses for use with the TCP/IP protocol. See "Using the SetIP program" on page 30.

SYSTEM REQUIREMENTS

Before you begin, ensure that your system meets the following requirements:

Windows

	REQUIREMENT (RECOMMENDED)
OS
	CPU	RAM	FREE HDD
			SPACE
Windows 2000	Pentium II 400 MHz	64 MB	600 MB
	(Pentium III 933 MHz)	(128 MB)
Windows XP	Pentium III 933 MHz	128 MB	1.5 GB
	(Pentium IV 1 GHz)	(256 MB)
Windows	Pentium III 933 MHz	128 MB	1.25 GB to
Server 2003	(Pentium IV 1 GHz)	(512 MB)	2 GB
Windows	Pentium IV 3 GHz	512 MB	15 GB
		(1024 MB)
Windows	Pentium IV 1 GHz	512 MB	10 GB
Server 2008	(Pentium IV 2 GHz)	(2048 MB)
Windows 7	Pentium IV 1 GHz 32-	1 GB	16 GB
	bit or 64-bit processor	(2 GB)
	or higher

•Support for DirectX 9 graphics with 128 MB memory(to enable the Aero theme).

•DVD-R/W Drive

Windows	Pentium IV 1	512 MB	10 GB
Server 2008	GHz(x86) or	(2048 MB)
R2	1.4GHz(x64)
	processors(2GHz or
	faster)

26 _Getting Started