XiNCOM XC-DPG603 manual Connecting two broadband modems, a Procedure

Connecting two broadband modems

aProcedure

1.Ensure the XC-DPG603 and the DSL/Cable modem are powered OFF. Leave the modem or modems connected to their data line.

2.Connect the Broadband modem(s) to the XC-DPG603.

If using only one (1) Broadband modem, connect it to the “WAN 1” port.

3.Use standard LAN cables to connect PCs to the LAN ports on the XC-DPG603.

Both 10BaseT and 100BaseT connections can be used simultaneously.

Use a standard CAT-5 Ethernet cable to connect any port on the XC-DPG603 to a standard port on another hub. Any LAN port on the will automatically act as an “Uplink” port when required.

4. Power Up

Power on the Cable or DSL modem(s).

Connect the supplied power adapter to the XC-DPG603 and power up.

5. Check the LEDs

The Power LED should be ON.

The WAN – Link LED should be ON when the corresponding WAN port is connected toa broadband modem.

For each PC connected to the LAN ports, the corresponding LAN LED (either 10 or 100) should be ON.

Figure 4. Installation Diagram for XC-DPG603

DC 5V WAN2 Reset LAN Ports WAN1

Broadband Modem Broadband Modem

Local Area Network

12