XiNCOM XC-DPG603 manual Port Options, Health Check Auto Dialup Bridge Mode

Port Options

Figure 6. Port Options

Connection Validation	PPPoE / PPtP Connection Options	Transparent Bridge Mode
Health Check	Auto Dialup	Bridge Mode
Use this field to select the type of connection validation	When set to Enable a connection will be established	When set to Enable, this WAN port does not use NAT &
to perform. When set to ICMP, the XC-DPG603 sends	whenever outgoing WAN traffic is detected. If not	Load Balance function when LAN/WAN IP have the real
out ICMP echo requests. When set to HTTP, the XC-	Enabled, you must establish a connection manually.	IP addresses on the same network segment.
DPG603 requests web pages.	Auto Disconnect	Traffic Management
Alive Indicator	This determines when an idle connection will be
This is the IP address used to check if the WAN	terminated. Enter the required time period.	Strict Binding - When a WAN port connection is
connection is operational. When using HTTP, put in a	Echo Time	disconnected, the packets will not go to another WAN
valid IP address of a web server. When this field is blank,	This determines how often an Echo request is sent to the	port.
the ISP gateway IP address is used.		Loose Binding - When the WAN port connection is
	PPPoE server. The Echo request is used to determine if
Note: This is not used for PPPoE connections.	the connection is still valid. Normally, there is no need to	connected, the packets will go another WAN port.
MTU	change the default value.	Load Balancing - This will mix real and private IP’s on
The Maximum Transmission Unit is used when	Echo Retry
		the LAN side doing the load balancing.
determining the packet size to be used on the WAN	The number of time the Echo request will be sent if there
interface. Normally, this does not need to be changed, but
	is no response to the first request. Normally, there is no
if your ISP advises you to use a particular MTU, enter it	need to change the default value.
here.
			17