XiNCOM XC-DPG603 manual VPN Policy Setup

Policy Setup

VPN Policy Setup

IPSec Traffic Binding

VPN Tunnel List

It shows the tunnels that you have entered. The router can setup up to 50 tunnels

Tunnel Name

This distinguishes different “tunnels” by name.

Tunnel

The tunnel can only be connected when the Enable check box is selected.

WAN port

You can choose WAN1, WAN2 or Any to make the VPN connection.

PPPoE Session

Some ISPs offer multiple sessions when using PPPoE to make the VPN connection. You can select these PPPoE sessions to construct VPN tunnels.

Traffic Selector

Service

Protocol Type: You can choose either TCP/UDP/ICMP/GRE protocol as your connection protocol. By default the protocol type is “Any”.

Local Security Network

These entries identify the private network on the VPN gateway and the hosts of which can use the LAN-to-LAN connection. You can choose a single IP address, the subnet, or a selected IP range to make VPN LAN-to-LAN connection.

Remote Security Network

These entries identify the private network on the remote peer VPN router whose hosts can use the LAN-to-LAN connection. You can choose a single IP address, the subnet, or a selected IP range to make VPN connection

Remote Security Gateway

You can either select remote side domain name or remote side IP address (WAN IP address) as your remote side security gateway.

Security Level

Encryption Method

It specifies the encryption mechanism to use. Data encryption makes the data unreadable if intercepted. There are three encryption method available: DES, 3DES and AES. The default is null.

Authentication

This specifies the packet authentication mechanism to use. Packet authentication confirms the data’s source. There are three authentications available: MD5, SHA1 and SHA2.

36