20
Using the AG-Stomp
●Using the AG-Stomp Without PatchesThe [MANUAL] button gives you direct control of the
AG-Stomp’s parameters and effects when patches
are not used.
Press the [MANUAL] button to enter the Manual
Mode (the lamp will light). In this mode, the tone
produced by the AG-Stomp is determined by the
current position of all knobs and effect buttons (with
the exception of the [FEEDBACK REDUCTION]
buttons), changes to any knob or button will have a
direct effect on the tone.
To exit the Manual Mode, simply recall any patch.
Press a Footswitch (1-3) that corresponds to the
patch number shown in the display to return the AG-
Stomp to the same condition previous to entering
the Manual Mode.
Also, the MANUAL Mode will be exited if the [SHIFT]
button is pressed to enter the SHIFT mode for edit-
ing one of the secondary parameters. At this time
the [MANUAL] button’s lamp will flash.
●Using a Foot Pedal (Controller)A foot controller (expression pedal) (optional) such
as the YAMAHA FC-7, etc. connected to the EXP.
PEDAL jacks can be used to control of the AG-
Stomp’s volume, tone or effect parameters (setting
values).
→page 22 [External Control Settings]
●Control the AG-Stomp From an Exter-nal MIDI DeviceAn external MIDI device’s MIDI OUT jack, connected
to the AG-Stomp’s MIDI IN jack via a MIDI cable
can be used to control the AG-Stomp’s volume, tone
or effect parameters (setting values).
→page 22 [External Control Settings]
●Chromatic Auto Tuner FunctionTo enter the Tuner Mode, press the [UTILITY] and
[STORE] buttons simultaneously, or hold the BANK
switch until “tu” appears in the display when in the
Play Mode. The Tuner Mode supplies you with a
chromatic auto tuner for tuning.
→page 23 [Tuner Mode]
●Factory DefaultTo return the AG-Stomp’s settings to their factory
default condition, simultaneously hold the [UP] and
[MANUAL] buttons and turn the Power ON ( ), all
data in the USER AREA will be rewritten with data
for the patches listed in the “Patch List” which can
be found on a supplemental sheet.