Installation

This section gives a step-by-step guide to installing the CRW8824S drive. Make sure you have all the necessary tools.

First Steps

Once you have taken the CRW8824S drive out of its packaging, you should immediately note down the serial number shown on the top of the drive together with a barcode. You may need to refer to this number when requesting User Support services. In the box below the following diagram, write down the 10- character serial number (consisting of 3 letters followed by 7 digits).

Drive’s serial number (3 letters + 7 digits)

CD-REWRITABLE DRIVE

MODEL NO. CRW8824S

MADE IN MALAYSIA

COMPLIES WITH 21 CFR CHAPTER 1, SUBCHAPTER J. YAMAHA CORPORATION

10-1 NAKAZAWA-CHO, HAMAMATSU-SHI, SHIZUOKA-KEN 430-8650, JAPAN MANUFACTURED;

MAY2000

YAMAHA CRW8824S

Tested To Comply

With FCC Standards

FOR HOME OR OFFICE USE

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired operation.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme á la norme

NMB-003 du Canada.

CLASS 1 LASER PRODUCT

LASER KLASSE 1 PRODUKT

LUOKAN 1 LASERLAITE

KLASS 1 LASER APPARAT

PRODUIT LASER DE CLASSE 1

CAUTION - VISIBLE AND / OR INVISIBLE LASER RADIATION WHEN OPEN. AVOID EXPOSURE TO BEAM.

VARNING - SYNLIG OCH / ELLER OSYNLIG LASERSTRÅLNING NÄR DENNA DEL ÄR ÖPPNAD. STRÅLEN ÄR FARLIG.

VARO ! AVATTAESSA OLET ALTTIINA NÄKYVÄLLE JA / TAI NÄKYMÄTÖMÄLLE LASERSÄTEILYLLE. ÄLÄ KATSO SÄTEESEEN.

VARNING - SYNLIG OCH / ELLER OSYNLIG LASERSTRÅLNING NÄR DENNA DEL ÄR ÖPPNAD. BETRAKTA EJ STRÅLEN.

VORSICHT ! SICHTBARE UND / ODER UNSICHTBARE LASERSTRAHLUNG WENN ABDECKUNG GEÖFFNET. NICHT DEM STRAHL AUSSETZEN.

ATTENTION - RADIATION VISIBLE ET / OU INVISIBLE LORSQUE L’APPAREIL EST OUVERT. EVITEZ TOUTE EXPOSITION AU FAISCEAU.

V561580-1F

Serial No.

Before fitting the CRW8824S drive into the computer, you need to set up the drive using the jumper switches located at the rear of the unit. You’ll need to set the following:

SCSI ID number

Parity check

Termination

Block size

8