Manuals / Brands / Home Audio / CD Player / Yamaha / Home Audio / CD Player

Yamaha CRW8824S, CRW8824S-NB 2Parity Check, 3Termination

1 51

Download 51 pages, 2.3 Mb

Installation

2Parity Check

The parity check is used for error correction during data transmissions. If parity- checking has to be disabled, the shunt on the Parity jumper switch should be removed.

Parity ON (Default)

Normally leave this setting alone.

Parity OFF

1 2 4

ID SELECT

PARITY

TERMINATOR BLOCK SIZE

1 2 4

ID SELECT

PARITY

TERMINATOR BLOCK SIZE

By factory default, the Parity switch is set to “ON” and should normally be left in this state.

3Termination

Terminators prevent SCSI signals from being reflected off the last device in the chain. The SCSI terminator switch should be set to “ON” if the CRW8824S is the last device on the internal SCSI chain. If the CRW8824S is not the last device on the internal SCSI chain, the shunt on the Terminator jumper switch should be removed.

Computer

Hard disk drive

(unterminated)CRW8824S (terminated)

MO drive

(terminated)

SCSI adapter card

Terminator

By factory default, the Terminator switch is set to “ON.”

Contents

Page COMPLIANCE INFORMATION STATEMENT Page Page SAFETY PRECAUTIONS PLEASE READ CAREFULLY BEFORE PROCEEDING WARNING CAUTION About CD-R/RWdiscs 2.All trademarks contained in this manual belong to their respective owners Precautions for Transportation Distributing Discs Copyrights Table of Contents Setup Flowchart Introduction Features of the CRW8824S Drive High speed CD TEXT support Wide compatibility System Configuration Computer Software Discs Tools Phillips Screwdriver Long-NosedPliers Front and Rear of Unit Front Panel Rear Panel Installation First Steps Rear Panel 1SCSI ID number 2Parity Check 3Termination 4Block Size Installing the CRW8824S Drive Fitting the CRW8824S as an Additional Drive Remove the front cover of a vacant About SCSI adapter card termination Page Page Connect a )Attach the outer casing of the computer and any screws that were removed !Reconnect the computer to the AC outlet and power it up Double-click $Install the CD writing software Replacing an Existing CD-ROMDrive with the CRW8824S Page Remove the four screws holding the Page Page Connect the !Attach the outer casing of the computer and any screws that were removed @Reconnect the computer to the AC outlet and power it up %Install the CD writing software Operation Loading a Disc Ejecting the Disc Manually Ejecting a Disc in an Emergency Troubleshooting OFF The disc tray does not come out The disc keeps being ejected The drive does not operate correctly The “Buffer Underrun” error message is displayed Appendix Writing Modes Disc-at-Once(DAO) Track-at-Once(TAO) Session-at-Once(SAO) Packet Writing About the firmware Determining the firmware version of the CRW8824S drive (in Windows 95/98/98SE) LED Indicator Messages CRW8824S Specifications Page Index EUROPE, EASTERN EUROPE and RUSSIA U.S.A CANADA AUSTRALIA TAIWAN