Yamaha CRW8824S, CRW8824S-NB 1SCSI ID number

Installation

1SCSI ID number

Each of the SCSI devices connected to the computer is identified by its SCSI ID number. You need to assign a number from “0” to “7” for each SCSI device. Commonly, ID number “7” is reserved for the computer’s SCSI adapter card itself. Therefore, the CRW8824S can actually be assigned an ID number from “0” to “6.” The ID number is set by attaching/detaching the shunts on the ID Select jumper switches according to the diagram shown below.

SCSI ID 0			SCSI ID 1			SCSI ID 2
	ID SELECT			ID SELECT			ID SELECT
	PARITY			PARITY			PARITY
	TERMINATOR			TERMINATOR			TERMINATOR
	BLOCK SIZE			BLOCK SIZE			BLOCK SIZE
1 2 4		1 2 4			1 2 4

SCSI ID 3 (Default)		SCSI ID 4		SCSI ID 5
	ID SELECT		ID SELECT		ID SELECT
	PARITY		PARITY		PARITY
	TERMINATOR		TERMINATOR		TERMINATOR
	BLOCK SIZE		BLOCK SIZE		BLOCK SIZE
		1 2 4		1 2 4
1 2 4

SCSI ID 6

SCSI ID 7

1 2 4

ID SELECT PARITY TERMINATOR BLOCK SIZE

1 2 4

ID SELECT PARITY TERMINATOR BLOCK SIZE

The SCSI ID number for each device on the chain must be unique. Make sure the CRW8824S drive’s SCSI ID number is not the same as that of any other device on the chain. By factory default, the CRW8824S is assigned ID number“3”but this can be changed.

If the SCSI card supports SCAM and SCAM is turned “ON,” a different ID number may be assigned if the SCSI ID number on the rear panel coincides with another SCSI device.

10