Moving Parts 99
D24—Owner’s Manual
Moving Parts
The Part Move function is used to move part of a track. Existing material on the desti-
nation track is overwritten by the Move function. The part on the source track is left
empty.
The following points, which can be adjusted in sub-frame steps, can be selected when
specifying edit points: LAST REC IN, LAST REC OUT, A, B, or a locate memory from
1 through 99. Note that you must set these points before entering the Part Move func-
tion. See the Quick Locate Chapter on page 57 for more information about setting
these points.
1Press the [EDIT] button.
The EDIT indicator lights up.
2Use the JOG/DATA dial to select “PART EDIT,” and then press the [ENTER] but-
ton.
3Use the JOG/DATA dial to select “MOVE,” and then press the [ENTER] button.
“PART MOVE—FROM TR nn” appears on the display (“nn” being the number of the
track from which the part is to be moved).
4Use the JOG/DATA dial to select the source track.
You can select individual tracks, track pairs, or all tracks: 1–8, 1/2–7/8, or ALL. To move
part of a virtual track, assign it to a main track first, and then move.
5Press the [ENTER] button.
“MOVE TR nn—ST MARK IN” appears on the display (“nn” being the number of the
selected track and “ST” being the start point of the part to be moved).
6Use the JOG/DATA dial to select one of the following points: MARK IN, MARK
OUT, MARK A, MARK B, or a locate memory from 1 through 99.
7Press the [ENTER] button.
“MOVE TR nn—ST 00:00:00.00.0” appears on the display (“00:00:00.00.0” being the
position of the selected point).
8Use the JOG/DATA dial or keypad to adjust the start position, and then press
the [ENTER] button.
“MOVE TR nn—ED MARK IN” appears on the display (“ED” being the end point of
the part to be moved).
9Use the JOG/DATA dial to select one of the following points: MARK IN, MARK
OUT, MARK A, MARK B, or a locate memory from 1 through 99.
10 Press the [ENTER] button.
If the duration of the specified part is less than 15 milliseconds, the minimum size, the
message “TOO SHORT” appears.
“MOVE TR nn—ED 00:00:00.00.0” appears on the display (“00:00:00.00.0” being the
position of the selected point).
11 Use the JOG/DATA dial or keypad to adjust the end position, and then press
the [ENTER] button.
“MOVE TR nn—TO TR nn” appears on the display (“TO TR nn” being the destination
track).