104 Chapter 10—Editing Parts
D24—Owner’s Manual
Erasing Parts
The Part Erase function is used to erase part of a track. The erased part is left empty.
The following points, which can be adjusted in sub-frame steps, can be selected when
specifying edit points: LAST REC IN, LAST REC OUT, A, B, or a locate memory from
1 through 99. Note that you must set these points before entering the Part Erase func-
tion. See the Quick Locate Chapter on page 57 for more information about setting
these points.
1Press the [EDIT] button.
The EDIT indicator lights up.
2Use the JOG/DATA dial to select “PART EDIT,” and then press the [ENTER] but-
ton.
3Use the JOG/DATA dial to select “ERASE,” and then press the [ENTER] button.
“PART ERASE—TR nn” appears on the display (“nn” being the number of the track
from which the part is to be erased).
4Use the JOG/DATA dial to select the track.
You can select individual tracks, track pairs, or all tracks: 1–8, 1/2–7/8, or ALL. To erase
part of a virtual track, assign it to a main track first, and then erase.
5Press the [ENTER] button.
“ERS TR nn—ST MARK IN” appears on the display (“nn” being the number of the
selected track and “ST” being the start point of the part to be erased).
6Use the JOG/DATA dial to select one of the following points: MARK IN, MARK
OUT, MARK A, MARK B, or a locate memory from 1 through 99.
7Press the [ENTER] button.
“ERS TR nn—ST 00:00:00.00.0” appears on the display (“00:00:00.00.0” being the
position of the selected point).
8Use the JOG/DATA dial or keypad to adjust the start position, and then press
the [ENTER] button.
“ERS TR nn—ED MARK IN” appears on the display (“ED” being the end point of the
part to be erased).
9Use the JOG/DATA dial to select one of the following points: MARK IN, MARK
OUT, MARK A, MARK B, or a locate memory from 1 through 99.
10 Press the [ENTER] button.
If the duration of the specified part is less than 15 milliseconds, the minimum size, the
message “TOO SHORT” appears.
“ERS TR nn—ED 00:00:00.00.0” appears on the display (“00:00:00.00.0” being the
position of the selected point).
11 Use the JOG/DATA dial or keypad to adjust the end position, and then press
the [ENTER] button.
“EDIT ERASE—ARE YOU SURE” appears on the display.