106 Chapter 10—Editing Parts
D24—Owner’s Manual
Inserting Parts
The Part Insert Space function is used to insert an empty part into a track. Existing
material on the track is moved backward.
The following points, which can be adjusted in sub-frame steps, can be selected when
specifying edit points: LAST REC IN, LAST REC OUT, A, B, or a locate memory from
1 through 99. Note that you must set these points before entering the Part Insert Space
function. See the Quick Locate Chapter on page 57 for more information about setting
these points.
1Press the [EDIT] button.
The EDIT indicator lights up.
2Use the JOG/DATA dial to select “PART EDIT,” and then press the [ENTER] but-
ton.
3Use the JOG/DATA dial to select “INSERT SPACE,” and then press the [ENTER]
button.
“PART INSR S—FROM TR nn” appears on the display (“nn” being the number of the
track into which the empty part is to be inserted).
4Use the JOG/DATA dial to select the track.
You can select individual tracks, track pairs, or all tracks: 1–8, 1/2–7/8, or ALL. To insert
an empty part into a virtual track, assign it to a main track first, and then insert.
5Press the [ENTER] button.
“INSR TR nn—ST MARK IN” appears on the display (“nn” being the number of the
selected track and “ST” being the start point of the part to be inserted).
6Use the JOG/DATA dial to select one of the following points: MARK IN, MARK
OUT, MARK A, MARK B, or a locate memory from 1 through 99.
7Press the [ENTER] button.
“INSR TR nn—ST 00:00:00.00.0” appears on the display (“00:00:00.00.0” being the
position of the selected point).
8Use the JOG/DATA dial or keypad to adjust the start position, and then press
the [ENTER] button.
“INSR TR nn—ED MARK IN” appears on the display (“ED” being the end point of the
part to be inserted).
9Use the JOG/DATA dial to select one of the following points: MARK IN, MARK
OUT, MARK A, MARK B, or a locate memory from 1 through 99.
10 Press the [ENTER] button.
If the duration of the specified part is less than 15 milliseconds, the minimum size, the
message “TOO SHORT” appears.
“INSR TR nn—ED 00:00:00.00.0” appears on the display (“00:00:00.00.0” being the
position of the selected point).
11 Use the JOG/DATA dial or keypad to adjust the end position, and then press
the [ENTER] button.
“EDIT INSR S—ARE YOU SURE” appears on the display.