A–B Repeat Playback 47
D24—Owner’s Manual
A–B Repeat Playback
A–B Repeat playback can be used to repeatedly play a specific part of a project, with
playback cycling between the specified A and B points, as shown below.
To use the A–B Repeat function, you must first set the A and B points, which can be set
while the D24 is stopped or during rewind, fast forward, playback, recording, or
rehearsal, but cannot be changed during A–B repeat playback.
1While holding down the [SET] button, press the [A] button to set the A point,
and then the [B] button to set the B point.
When a point is set, the corresponding indicator (A or B) lights up and the stored posi-
tion appears on the 2nd line of the display. See “Using the A & B Points” on page 61 for
more information about setting the A and B points.
2Press the [REPEAT] button.
The REPEAT indicator lights up.
3Press the [PLAY] button to start repeat playback.
Playback cycles between the A and B points.
Repeat playback can also be started by pressing the [REPEAT] button during playback.
If the [REPEAT] button is pressed during repeat playback, the D24 cancels repeat play-
back and continues with normal playback.
4Press the [STOP] button to stop playback.
5Press the [REPEAT] button to cancel A–B Repeat.
The REPEAT indicator goes out.
A–B Repeat playback plays from the lowest point to the highest, so if the B point occurs
before the A point, playback cycles from B to A.
The A and B points for each project are saved to disk automatically.
Repeat playback
A
point B
point
A
point B
point
SETSET AB