Menu items
◆Setup
Location
Designate the location of the main unit.
Choices: [Front/Table] [Front/Ceiling] [Rear/Table] [Rear/Ceiling] (☞ page 12)
V Keystone Correction
Adjusts the projection angle of the image.
If you do not install the projector at right angles to the screen, the image will be trapezoidally distorted. You can electronically correct this distortion using this function to adjust the width without changing the height of the image. Increase the keystone value (0 to +50 ) when the upper part of the image is overly wide, and reduce it
When the upper part of | When the lower part of |
the image is wider than the lower part | the image is wider than the upper part |
Increase the value | Decrease the value |
in the positive (+) direction | in the negative |
H Keystone Correction
Adjusts the projection angle of the image.
If you do not install the projector at right angles to the screen, the image will be trapezoidally distorted. You can electronically correct this distortion using this function to adjust the height without changing the width of the image. Increase the keystone value (0 to +50 ) when the right side of the image is overly high, and reduce it
When the right side of | When the left side of |
the image is higher than the left side | the image is higher than the right side |
Increase the value | Decrease the value |
in the positive (+) direction | in the negative |
Remote Control Sensor
Sets the remote control sensor.
The main unit has two remote control sensors, one on the front panel and one on the rear, which this setting allows you to switch between. The remote control functions regardless of the setting of this parameter if you use a wired connection to connect it to the main unit. Choices: Front & Rear/Front/Rear/Off
Remote Control ID | Sets the remote control ID. |
| Selects ID1 or ID2 for each main unit when operating two main units with one remote |
| control. You can select the controllable main unit with the remote control code switch on |
| the remote control. |
| Choices: ID1/ID2 |
|
|
Lens Adjustment Lock | Locks the lens adjustment function. |
| Locks the lens so that you cannot change the V.POS, ZOOM, and FOCUS settings |
| accidentally when set to [ON]. Set to [OFF] to cancel this function. |
Lamp Power
Lowers the power supply to the lamp.
You can adjust the power supplied to the lamp within the range of 80 to 100%.
36
