UP DN

q

E

 

ADJUSTING TRIM ANGLE

 

EMU01401

UP

Power Trim/Tilt Model

DN

 

w

8Be sure all people are clear of the outboard motor when adjusting the trim/tilt angle, also be careful not to

701034*

pinch any body parts between the drive unit and clamp bracket.

8Use caution when trying a trim position for the first time. Increase speed gradually and watch for any signs of instability or control problems.

8Use the power trim/tilt switch located on the bottom engine cowling (if equipped) only when the boat is at a complete stop with the engine off.

The outboard motor trim angle can be adjusted operating the power trim/tilt switch 1.

To raise the bow (“trim-out”), push the switch UP.

To lower the bow (“trim-in”), push the switch DN.

Make test runs with the trim set to different angles to find the position that works best for your boat and operating condi- tions.

NOTE:

To adjust the trim angle while the boat is moving, use the power trim and tilt switch located on the remote control device or tiller handle, if so equipped.

3-15