E

q rew

yt

001146

602053

EMU00976

Removing the Propeller

1)Straighten the cotter-pin 1 and pull it out using a pair of pliers.

2)Remove the propeller nut 2, washer 3 and spacer 4.

3)Remove the propeller 5 and thrust washer 6.

EMU00397

Installing the Propeller

cC

8Be sure to install the thrust washer before installing propeller, otherwise, lower case and propeller boss may be damaged.

8Be sure to use a new cotter pin and bend the ends over securely. Other- wise, the propeller could come off during operation and be lost.

1)Apply Yamaha Marine grease or Cor- rosion resistant grease to the pro- peller-shaft.

2)Install the thrust washer and propeller on the propeller-shaft.

3)Install the spacer and washer. Tighten the propeller nut to the specified torque.

Tightening torque:

Refer to “SPECIFICATIONS” page 4-1.

4)Align the propeller nut with the pro- peller shaft hole. Insert a new cotter pin in the hole and bend the cotter pin ends.

NOTE:

If the propeller nut does not align with the propeller shaft hole after tightening to the specified torque, then tighten the nut further to align it with the hole.

4-24