Yamaha MD4S owner manual Stereo Inputs, Monitor/Master section

Front and rear panel 15

Stereo Inputs

H Level (5/6), (7/8) controls

These controls adjust the level of the signals input from STEREO INPUT jacks 5/6 or 7/8. These input signals are always sent to the ST bus, and are mixed with the signals from input channels 1–4 and the playback signals of the tracks.

5 / 6 7 / 8

8
0	10	0	10

Monitor/Master section

I CUE MIX TO STEREO switch

This switch turns the cue mix function on/off. When the switch is pressed in (), the CUE MIX indicator in the display will light, and the signal from the CUE bus will be mixed into the ST bus.

The cue mix function can be used only during playback, and is normally used when adding sounds during mixdown (page 42).

J MONITOR SELECT switches

These switches select the signal that will be monitored from the MONITOR OUT jacks (rear panel 4) and the PHONES jack (front panel 1). When the switch is pressed in, the corresponding source is selected (on). When the switch is up, the signal will not be selected (off). The three switches can be turned on/off independently.

2TR IN	Monitor the signal that is input from the 2TR
	IN jacks (rear panel 6).
STEREO	Monitor the ST bus signal that is output from
	the STEREO OUT jacks (rear panel 5).
CUE	Monitor the CUE bus signal.

K MONITOR LEVEL control

This control adjusts the output level of the monitor signal that is sent to the MONITOR OUT jacks (rear panel 4) and the PHONES jack (front panel 1).

L STEREO fader

This adjusts the output level of the ST bus that is output from the STEREO OUT jacks (rear panel 5). The fader will be at unity gain when located between 7 and 8.

Unity gain: Refer to the explanation of 7Fader.

CUE MIX TO STEREO

9

MONITOR SELECT

2TR IN

STEREO

J

CUE

MONITOR LEVEL

K
	MIN	MAX
	10	10
	9	9
	8	8
	7	7
L	6	6
	5	5
	4	4
	3	3
	2	2

11

0 0

STEREO

—Owner’s Manual