Yamaha RX-497 @ Infrared signal transmitter, Sends infrared signals, @ Input selector buttons

This section describes the function of each button on the remote control used to control this unit or other

components made by YAMAHA or other manufacturers. The functions of the buttons used to control your other

audio and video components are the same as those of the

con'esponding buttons on those components. Refer to

those components' instruction manuals for details. To

operate other components using this remote control, see

"REMOTE CONTROL FEATURES" on page 39.

0}

..............:?;

............:g;,

o<9)

......10_

,,<}

.........84"_

@Infrared signal transmitter

Sends infrared signals.

@Input selector buttons

Select the desired input source and change the control area (see page 39).

_O]_TII;{O]Jk'JF:hqlI_IJ_T[elI[O]_Tg

@ Numeric buttons

Select the preset station number (I to 8) when TUNER is selected as the input source.

Select the preset channel number when XM is selected as the input source.

@BAND

Switches to the previously used reception band (FM or AM) when TUNER is selected as the input source.

The frequency of the previously received station is autoznatically recalled.

@A-E/CAT.(CATEGORY) < / >

Selects the preset station group (A to E) when TUNER is selected as the input source (see page 25).

Switches between channel categories or selects the preset channel group (A to E) when XM is selected as the input source (see page 31).

PRESET/CH ,t", / v

Selects the preset station number (1 to 8) when

TI__ER is selected as the input source (see page 25). Searches for a radio channel or selects the preset channel number (1 to 8) when XM is selected as the input source (see page 29).

@MEMORY

Stores a radio channel in the system memory when XM is selected as the input source (see page 33).

@STANDBY

Sets this unit to the standby mode.

•This button is operational only when MASTER ON/OFF on the front panel is pressed inward to the ON position.

•In the standby mode, this trait consnmes a small amount of power to receive infrared signals from the remote control.

•This bntton does not set Zone 2 to the standby mode.

@POWER

Turns on this unit.

•This button is operational only when MASTER ONOFF on the front panel is pressed inward to the ON position.

•This button does not turn on Zone 2.