Yamaha RX-497 owner manual Press SPEAKERS

[e!':1Ii tl'olAVl

Ex_eme caution should be exercised when you play back CDs encoded in DTS.

If you play back a CD encoded in DTS on a DTS-mcompatible CD player, you will only hear some unwanted noise that may damage yottr speakers. Check whether your CD player supports CDs encoded in DTS. Also, check the sound output level of your CD player before you play back a CD encoded in DTS.

		2 Press SPEAKERS		A and/or SPEAKERS B on
		the front panel or on the remote control to
		select speakers A and/or speakers B.
		SPEAKERS		8P[AKERS
		A	B
				or
		Front	panel	Remote control
5 1	2	•Both SPEAKERS A and B can be selected.
		•Make sure that the IMPEDANCE SELECTOR switch is
		correctly set (see page 11).

E

1-

-2

-4

Rotate the INPUT selector on the front panel (or press one of the input selector buttons on the remote control) to select the desired input source.

INPUT

or

Front panel Remote control

3Play the source.

4Rotate VOLUME on the front panel (or press VOLUME +/-onthe remote control)to adjust the sound output level.

or

Front panel Remote control

Press MAIN ZONE ON/OFF on the front panel again (or press STANDBY on the remote control) to finish using this unit and set it to the standby mode.

MA_N ZONE

Front panel Remote control

15