1Remove approximately 10 mm (3/8 in) of insulation from the end of each speaker cable and twist the exposed wires of the cable together to prevent short circuits,
10 mm (3/8 in)i I _ _
Unscrew the knob.
Red: positive (+)
Black: negative
Insert one bare wire into the hole in the side of each terminal.
Red: positive (+)
Black: negative
4Tighten the knob to secure the wire.
Red: positive (+)
Black: negative
•Connecting the banana plug
(U.S.A., Canada, Australia and General
models only)
First, tighten the knob and then insert the banana plug into
the end of the corresponding temfinal.
Banana plug
•One or two speaker sets can be connected to this unit. If you use only one speaker seL connect it to either the SPEAKERS A or B terlninals.
•Use speakers with the specified impedance shown on the rear panel of this unit.
•IMPEDANCE SELECTOR
[O'-IIHL'o/AR'
Do not slide the IMPEDAN(E SELECTOR switch while the power of this trait is turned on, as doing so may damage the trait.
Select the switch position (left or right) according to the
impedance | of the speakers in | your system. |
| |
Switch |
|
|
|
|
position |
| Impedance level |
| |
| If you | use one | set (A or B), the impedance | of |
| each speaker nmst be 8 _ or higher. |
| ||
Right |
|
|
|
|
| If you | use two | sets (A and B), the impedance | |
| of each speaker nmst be 16 _ or higher. |
| ||
| If you | use one | set (A or B), the impedance | of |
Left | each speaker nmst be 4 _ or higher. |
| ||
|
|
|
| |
| If you | use two | sets (A and B), the impedance | |
| of each speaker nmst be 8 _ or higher. |
| ||
•The Canada model cannot use two speaker sets (A and B)
simultaneously when the IMPEDAN(E SELECTOR switch is slid to the right position.
•If this unit ±;ailsto turn on. the IMPEDANCE SELECTOR switch may not be fully slid to either position. If this is the case. slide the switch all the way to either position when the power supply to this unit is completely cut of£
11
