Choices: SET, CANCEL
•Select “SET” to confirm the “AUTO SETUP” results.
•Select “CANCEL” to cancel the “AUTO SETUP” results.
The top “SET MENU” display appears in the OSD.
SET MENU
TOP MENU
.;AUTO SETUP
;MANUAL SETUP
.A;SIGNAL INFO
[p]/[p]:Up/Down [ENTER]:Enter
The optimizer microphone is sensitive to heat. Keep it away from direct sunlight and do not place it on top of this unit.
y
If you change speakers, speaker positions, or the layout of your listening environment, run “AUTO SETUP” again to recalibrate your system.
Press 8k / n / l / h to select “RETRY” or “EXIT” and then press 8ENTER.
The following display is an example where
ERROR
.
>RETRY EXIT
[]/[]:Select [ENTER]:Enter
Choices: RETRY, EXIT
•Select “RETRY” to retry the “AUTO SETUP” procedure.
•Select “EXIT” to exit from the “AUTO SETUP”
procedure.
Optimizing the speaker setting for your listening room
When this unit detects potential problems during the “AUTO SETUP” procedure, “WARNING” appears in the result display. Check the warning messages to correct your speaker settings.
Note
Warnings differ from errors in that warnings do not cancel the “AUTO SETUP” procedure.
1Make sure the pointer is pointing at “WARNING” and then press 8ENTER to
The number on the right of “WARNING” indicates the number of warning messages.
AUTO SETUP
.WARNING(2)
RESULT
SP : 3/2/0.1
DIST: 3.2/3.5m
LVL :
>SET CANCEL
[ ]/[ ]:Up/Down
[ENTER]:Detail
WARNING
Reverse channel
AAACENTER
[]/[]:Select [ENTER]:Return
y
•For details about each warning message, see the “AUTO SETUP” section in “Troubleshooting” on page 90.
•When the corresponding warning message is not applicable to a speaker, “–
PREPARATION
English