Setting the speaker impedance
Caution
If you are to use 6 ohm speakers, set “SP IMP.” to “6Ω MIN” as follows BEFORE using this unit.
1Press C SYSTEM OFF on the front panel to set this unit to the standby mode.
Refer to the right column for details.
2Press and hold N TONE CONTROL and then press A MAIN ZONE ON/OFF to turn
on this unit.
This unit turns on, and the advanced setup menu appears in the front panel display.
| While holding |
|
TONE CONTROL | down | MAIN ZONE |
| ||
|
| ON/OFF |
3Press O PROGRAM l / h to select “SP
IMP.”.
“SP IMP.” and the current speaker impedance setting (“8Ω MIN”) appear in the front panel display.
4Press P STRAIGHT repeatedly to select “6Ω
MIN”.
5Press A MAIN ZONE ON/OFF to save the new setting and turn off this unit.
Note
The setting you made is reflected next time you turn on this unit.
Connections
Turning on and off the power
■Turning on this unit
Press A MAIN ZONE ON/OFF (or HPOWER)
to turn on this unit.
y
When you turn on this unit, there will be a 4 to
■Set this unit to the standby mode
Press A MAIN ZONE ON/OFF (or
ISTANDBY) to set this unit to the standby mode.
In the standby mode, this unit consumes a small amount of power in order to receive infrared signals from the remote control.
y
You can set the main zone and zone 2 to the standby mode simultaneously by pressing C SYSTEM OFF.
PREPARATION
English
