Yamaha RX-V730 Press AMP to select the, to output, Test, test tone, AMP mode, Press TEST

This section explains how to adjust speaker output levels

using the test tone generator. When this adjustment is

complete, the output level heard at the listening position should be the same from each speaker. This is important

for best performance of the digital sound field processor, and the various decoders (Dolby Digital, Dolby Pro Logic, Dolby Pro Logic lI and DTS).

•Since this unit cannot enter the test mode while headphones are

connected to this unit, be sure to unplug the headphones from the PHONES jack when using the test tone.

	2				3
[] Turn	on	the	video	monitor	connected	to this
unit.
Press	SPEAKERS			A or B	SPEAKERS
to select		the	main		_>	Q--,
speakers		to	be used.			",!:;

If you are using two sets of the

main speakers, press both A and B.

[] Set the BASS and TREBLE controls on the

front panel to the center position.

BASSTREBLE

®Q

Use the test tone to balance the output levels of the

speakers. The adjustment of each speaker output level should be made at your listening position using the remote control.

3

[]	Press AMP to select the			AMP
	AMP mode.
	"AMP" appears in the display
	window on the remote control.
[]	Press TEST	to output	the	TEST
	test tone.
[]	Adjust the	volume of	this unit	so you can

hear the test tone.

The test tone is heard (in order) from the main left speaker, center speaker, main fight speaker, rear fight speaker, rear center, rear left speaker, and the subwoofer. The tone is produced for 2.5 seconds from each speaker.

VOLUMEor

Front panel Remote control

22