How to Connect:

Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is the + and – markings are observed. If these wires are reversed, the sound will be unnatural and lack bass.

Caution

Do not let the bare speaker wires touch each other and do not let them touch any metal part of this unit. This could damage this unit and/or speakers.

For connecting to the MAIN SPEAKERS terminals
For connecting to the REAR and CENTER SPEAKERS terminals

Red: positive (+)

Black: negative (–)

2

1

3

➀Unscrew the knob.

➁Insert the bare wire. [Remove approx. 5mm (1/4”) insulation from

the speaker wires.]

➂Tighten the knob and secure the wire.

Red: positive (+)

Black: negative (–)

➀

➂

➁

➀Press the tab.

➁Insert the bare wire. [Remove approx. 5mm (1/4”) insulation from the speaker wires.]

➂Release the tab and secure the wire.

<U.S.A., Canada, China and General models only>

Banana Plug connections are also possible. Simply insert the

Banana Plug connector into the corresponding terminal.

MAIN LEVEL switch

Normally set to “0 dB”. If desired, you can decrease the output level at the MAIN SPEAKERS terminals by 10 dB by setting this switch to “–10 dB”.

MAIN LEVEL

—I0dB 0dB

16