Yamaha RX-V793 CLEARING LEARNED FUNCTIONS, Trouble shooting guide, To Clear a Learned Function, To Clear All Learned Functions, OFF, Note, SLOW, work, LEARN, CLEAR, CLEAR

CLEARING LEARNED FUNCTIONS

To Clear a Learned Function

1 To clear a learned key function, press the LEARN button using the point of a mechanical pencil, etc.

To clear a macro you made, press the MACRO button.

or

TRANSMIT

/LEARN

CLEAR LEARN MACRO

Flashes slowly.

2 Press and hold the CLEAR button using the point of a mechanical pencil, etc.

CLEAR LEARN MACRO

3 Holding the CLEAR button pressed, press and hold the key whose function you want to clear until the indicator flashes 3 times.

CD	TRANSMIT
	/LEARN

Flashes.

To clear two or more functions sequentially, do not release the CLEAR button pressed, and repeat this step.

Note

If you clear a learned function of a key, the originally preset function of the key is restored (except the keys which are originally preset with no function.)

Trouble shooting guide

To Clear All Learned Functions

1 Select the kind of key functions all of which you want to clear by using the MACRO switch on the side panel of the remote control transmitter.

SLOW QUICKOFF MACRO

OFF: Select this position if you want to clear all of the learned functions except macros.

QUICK: Select this position if you want to clear all of the macros you made only.

SLOW: Select this position if you want to clear all of the learned functions including macros.

2 Press the CLEAR button using the point of a mechanical pencil, etc.

TRANSMIT

/LEARN

CLEAR LEARN MACRO

Flashes slowly.

*If one of the following operation is made after you press the CLEAR button, the TRANSMIT/LEARN indicator flashes rapidly and the current mode is canceled. If this occurs, press the CLEAR button again.

•MACRO switch is switched to another position.•Another key is pressed.•There is no operation for about 30 seconds.

3 Press and hold the CLEAR button again. While holding the CLEAR button pressed, press and hold the

MASTER VOLUME and keys simultaneously until the indicator flashes 7 times.

TRANSMIT

/LEARN

MUTE

Flashes.

SYMPTOM	CAUSE	REMEDY
The remote control transmitter does not	The batteries of this remote control	Replace the batteries with new ones and
work.	transmitter are weak.	press the RESET button on the remote
	The internal microcomputer “freezes”.	control transmitter.
Learning cannot be made successfully.	The batteries of this remote control	Replace the batteries (and press the RESET
	transmitter and/or the other remote control	button for this remote control transmitter).
(The TRANSMIT/LEARN indicator does not
	transmitter are weak.
light up or flash.)
	The distance between the two remote control	Place the remote control transmitters with the
	transmitters is too long or too short.	proper distance.
	The signal coding or modulation of the other	Learning is not possible.
	remote control transmitter is not compatible
	with this remote control transmitter.
	Memory capacity is full.	Further learning is not possible without
		deleting unnecessary commands.
	The internal microcomputer “freezes”.	Press the RESET button on the remote
		control transmitter.

52