Yamaha SW1000XG-E Installing the Plug-InBoard, Installing the Digital Mixing Card, Output from the SW1000XG to the DS2416 digital mixing card

Installing the Plug-In Board

Refer to the illustration below to install an optional plug-in board (PLG100 series).

Making sure that the plug-in board is facing in the correct direction, carefully press the cable from the plug-in board into the plug-in board connector on the sound card.

Make sure that the flat cable is

Connector to SW1000XGfacing in the correct direction. Connector to plug-in board

		Flat cable's
	Yellow line	connector
		First, put the four spacers in
Hooks	To plug-in board	the SW1000XG, then fit
		the plug-in board above
Spacer		the sound card.
	To SW1000XG

SW1000XG sound card

Plug-in board

Yellow line

Spacer

nThis should be done before the sound card is installed in the computer.

nFor information about each plug-in board, see page 24 and the owner’s manual that comes with each board.

Installing the Digital Mixing Card

Refer to the illustration below to install an optional digital mixing card (DS2416).

Making sure that the flat cable from the digital mixing card (DS2416) is facing in the correct direction, carefully press the cable into the digital mixing card connector on the sound card.

Green line

Connector to DS2416

Connector to SW1000XGMake sure that the flat cable from the DS2416 is facing in the correct direction.

SW1000XG sound card

DS2416

Green line Serial out Connector

Serial In Connector

nThis should be done before the sound card is installed in the computer.

nFor information about the digital mixing card (DS2416), refer to the owner’s manual that comes with the card.

Output from the SW1000XG to the DS2416 digital mixing card

In the initial setting, all parts of the SW1000XG are mixed in stereo and sent to the DS2416. However, you can send a specific part as an individual output to the DS2416, apart from the stereo output.

The SW1000XG is equipped with 6 individual outputs and each part (either MIDI multi part or audio part) can be assigned to any of the individual out 1 to 6, 1+2, 3+4 or 5+6.

For details, see MIDI Data Format tables <1-6> and <1-7>(MIDI Parameter Change tables), descriptions on “Output Select”.

The Output Select can be set using the XGworks’ XG Editor Window (The properties dialog box which opens when clicking on the [DETAIL] button of the part unit). If you are opening the multi part’s properties dialog box, the Output Select can be set in the General page of the Detail screen.

12