E
1.Put the watercraft on land in a horizontal position.
2.Open the flushing hose connector cap 1, and then insert the garden hose adapter 2 into the flushing hose connector 3 and turn it until it is securely connected.
3.Connect the garden hose adapter to a water tap using a hose.
4.Start the engine, and then immediately turn the water supply on until water flows out continually from the cooling water pilot outlet.
5.Run the engine at idling speed for about 3 minutes watching the engine condition. If the engine stops while flushing, turn the water supply off immediately and repeat the above steps.
6.Turn the water supply off, and then force the remaining water out from the cooling passages by alternately squeezing, and releasing the throttle lever for 10 to 15 seconds.
7.Stop the engine.
8.Remove the garden hose adapter and secure the cap.