Metering 23
01V96i—Owner’s Manual
Operating Basics
MeteringThis section describes how to check Input and Output
Channel levels using the Meter pages.
1. Press the FADER MODE [HOME] button
repeatedly until the Meter | Position
page appears.
This page enables you to set the metering position
for Input and Output Channels.
1INPUT section
This section enables you to select the metering
position for Input Channel and ST IN Channel sig-
nals.
2OUTPUT section
This section enables you to select the metering
position for Output Channel (Aux Out 1–8, Bus
Out 1–8, Stereo Out) signals.
2. Move the cursor to the desired parame-
ter button in the INPUT or OUTPUT sec-
tion, then press [ENTER].
You can select one of the following three positions
in each section.
•PRE EQ................Immediately before EQ.
•PRE FADER........Immediately before the fader.
•POST FADER.....Immediately after the fader.
3. Press the FADER MODE [HOME] button
repeatedly until the page listed below
that contains the desired channels
appears.
•CH1-32 page
This page displays the Input Channel 1–32 levels
respectively.
•ST IN page
This page dis plays the left and r ight ST IN Channel
1–4 levels separately.
•Master page
This s ect ion di spla ys t he O utp ut C han nel (Aux Out
1–8, Bus Out 1–8, Stereo Out) levels altogether.
1
2