Yeoman YM-CL8HB Running The appliance, User Instructions, Burning wood, 5.6Burning Solid Fuel

USER INSTRUCTIONS

5. Running The appliance

Burning wood:

5.1This appliance gives out its heat in two ways:

—Directly into the room in which it is fitted through convection and radiation.

—Hot water to heat radiators and domestic hot water. The output to hot water varies depending on how quickly the fuel is being burnt. Fore more detail see the graph on page 13.

5.2Only for use with recommended fuels, see Section 3 for full details.

—Close the Primary Air control and use the Airwash to control the burn rate when the appliance is at optimum operating temperature (see Diagrams 7 & 8).

7

PR8012

8

Airwash: Adjust

PR8937

—Wood burns best on a bed of ash (approx. 25mm (1") deep).

—Rake the embers evenly over the firebed and open the Airwash control fully for a few minutes before re-fuelling.

Do not refuel when a large amount of flames are present in the firebox as this could cause smoke or flames to spill into the room.

Close the doors immediately after refuelling.

5.3Burn new logs at a high temperature for a few minutes before adjusting the Airwash control. Refuel little and often for clean, efficient burning.

Do not load above the log guard or base of baffle.

5.4Do not burn large amounts of fuel with the Airwash control closed for long periods of time. This reduces the glass cleaning effect of the Airwash and causes tars and creosotes to build-up in the appliance and flue system.

5.5When in use, running the appliance at a high temperature for a short period reduces tars and creosotes.

5.6Experience establishes settings to suit personal preference.

Do not burn construction timber, painted, impregnated / treated wood, manufactured board products or pallet wood.

5.6Burning Solid Fuel

To burn smokeless fuels a cast iron multi-fuel grate must be fitted.

Only for use with recommended fuels (see User Instructions, Section 3).

5.7Set air controls as shown in Diagram 9.

9 Airwash

Primary Air

PR8933

8