The printing does not start at the top of the label, or misprinting of one to three labels.
■The media may not be threaded under the media guides. Refer to “Loading the Media” on page 9.
■The printer needs to be calibrated. Refer to “Auto Calibration” on page 14.
■The correct media sensor may not be activated. Manual calibration selects the media sensing method for the labels being used (refer to the ^MN command in the ZPL II Programming Guide).
■Verify that the Label Top (^LT) command is correctly set for your application (consult the ZPL II Programming Guide).
A label format was sent to, but not recognized by, the printer.
■Is the printer in pause mode? If so, press the feed button.
■If the status LED is on or flashing, refer to “What the Status LED is Telling You” on page 43.
■Make sure the data cable is correctly installed.
■A communications problem has occurred. First, make sure that the correct communications port on the computer is selected. Refer to “Communicating with the Printer” on page 18.
