Manuals / Zebra Technologies / Computer Equipment / Printer

Zebra Technologies R402 manual Manual Calibration

Models: R402

1 72

Download 72 pages 48.69 Kb

Page 57

Manual Calibration

Manual calibration is recommended whenever you are using pre-printed labels (or label backing) or if the printer will not correctly auto calibrate.

1.Turn on the printer power.

2.Remove approximately 4" (102 mm) of labels from a section of backing material. Load the media so that only the backing material is threaded through the printer and under the print head.

3.Press and hold the feed button until the green status LED flashes once, then twice. Release the feed button.

4.The printer will set the media sensor for the label backing being used. After it is done making this adjustment, the roll will automatically feed until a label is positioned at the print head.

5.A profile of the media sensor settings (similar to the example below) will print. Upon completion, the printer will save the new settings in memory and the printer is ready for normal operation.

6.Press the feed button. One entire blank label will feed. If this does not happen, try defaulting (refer to the four-flash sequence in “Feed Button Modes” on page 52) and recalibrating the printer.

NOTE: Performing a manual calibration disables the auto calibration function. To return to auto calibration, default the printer (see the four-flash sequence in “Feed Button Modes” on page 52).

Image 57

Zebra Technologies R402 manual Manual Calibration

Contents

Users Guide R402Page Proprietary Statement Page Contents Operation & Options Appendix 980389-001 Rev. a Hello Introduction What’s in the Box? Opening the printer Inspecting the Printer Inspecting the Printer Closing the printer Reporting Damage Modes of Printing Getting Started Attaching Power Supply Placing the Roll in the Media Compartment Loading Roll Media Adjusting the Guides Using the Optional Media Adapter Plates Install the Ribbon Supply Roll Install the Take-Up CoreLoading Ribbon Attach and Tighten the Ribbon Auto Calibration Operator Controls Power SwitchFeed Button Status Light Printing a Test Label Hooking Up the Printer and Computer Parallel Interface RequirementsInterface Cable Requirements Adjusting the Print Darkness Adjusting the Print WidthAdjusting the Print Speed Communicating with the Printer Thermal Printing Operation & Options Replacing Supplies Adding a New Transfer RibbonReplacing a Partially Used Transfer Ribbon Printing in Peel-Mode Printing on Fan-Fold Media Rfid Guidelines Supported Transponders Texas Instruments Tag-it Transponders Philips ICode Blocks Philips ICode Transponders Inside Technologies Picotag 2K Inside Technologies Picotag Transponders ISO-15693 Transponders WT Write Tag ZPL II Commands for Rfid RT Read Tag RT Read Tag RS Rfid Setup RI Rfid Get Tag Unique ID Sample of Rfid Programming WT6FDZebraFS FO100,100A0n,60FN0FS Page Maintenance CleaningLubrication Description Parts ListPage Removal Replacing the Print Head Cleaning the Print Head Page Resolutions TroubleshootingPrinter is not receiving power Printer is on and in an idle state There is a shortage of memory Printer has failed its power on self test PostPrinter is receiving data Either the media or ribbon is out Print head is under temperature Print head is over temperatureFlash memory is not programmed Ribbon sensor settings did not print Print Quality ProblemsNo print on the label Printed image does not look right Label format was sent to, but not recognized by, the printer Rfid tags generally not programmed Rfid SymptomsVoid messages are printed across media Nothing is printed Manual Calibration Troubleshooting Tests Printing a Configuration LabelRecalibration Communications Diagnostics Resetting the Factory Default Values Feed Button Modes Power Off Mode Communications Diagnostics Mode Appendix Physical Specifications Media Specifications Font/Code Specifications Options Parallel Interface Technical Information Page Cable calibration Index Quality problems Voltage Write tag command Page