57
Troubleshooting
RFID Error Codes and Messages
11/14/2008 RFID Programming Guide 58978L-008 Rev. A
800F INVALID AUTH KEY The key number does not exist or is invalid for authentication with
a specific reader or tag.
010A INVALID BAUD Internal problem with the reader. If the problem persists, contact
Technical Support.
0109 INVALID CMD The command does not exist or is invalid for the reader.
Internal problem with the reader. If the problem persists, contact
Technical Support.
9002 INVALID CMD The command does not exist or is invalid for the reader.
Internal problem with the reader. If the problem persists, contact
Technical Support.
9003 INVALID CRC Invalid CRC sent in the request to the reader. If the problem
persists, contact Technical Support.
9009 INVALID DATA LEN The length of the data specified in the request was invalid for the
command specified. If the problem persists, contact Technical
Support.
9006 INVALID FLAGS The flags specified were invalid for the command specified. If the
problem persists, contact Technical Support.
0104 INVALID FREQ The RFID reader received a command to set the frequency outside
of the supported range. If the problem persists, contact Technical
Support.
0500 INVALID FREQ The RFID reader received a command to set the frequency outside
of the supported range. If the problem persists, contact Technical
Support.
8014 INVALID KEY LEN The key length is not valid for the tag type, the command, or the
reader.
8013 INVALID KEY NO. The key number does not exist or is out of the range of valid keys.
9004 INVALID MESS LEN The number of bytes sent to the reader was invalid for the
command or for the message length passed in. If the problem
persists, contact Technical Support.
0101 INVALID OPCODE The opCode received by the RFID reader is invalid or not
supported with the current version of reader firmware. Make sure
you download the appropriate version of reader firmware. If the
problem persists, contact Technical Support.
OOOC
OOOD
INVALID PARAM The RFID reader received a valid command with an unsupported
or invalid value for one of the parameters. If the problem persists,
contact Technical Support.
0105 INVALID PARAM The RFID reader received a valid command with an unsupported
or invalid value for one of the parameters. If the problem persists,
contact Technical Support.
Table 6 • RFID Error and Status Message Definitions (Continued)
Error
Code RFID Error or
Status Message Des cription /Action Require d