Zebra Technologies radio frequency identification (rfid) RFID TAG CALIB

ZPL II Commands for RFID
^HR
86
58978L-008 Rev. A RFID Programming Guide 11/14/2008
Comments
• Based on the recommended transponder placement position for most RFID labels, the
printer’s default RFID programming position is zero for the R110PAX4. For other RFID
printers, the default programming position is the label length minus 1 mm (0.04 in.).
Toreturn to the default programming position at any time, use the RESTORE option in the
RFID TAG CALIB control panel parameter (see Calibrate RFID Tag onpage 23).
• To see the current programming position (shown in dot rows), refer to the printer
configuration label:
or use the SGD command rfid.position.program onpage 135.
• At the end of calibration, a results table is returned to the host. Each line in the results
table appears as:
Row, Read Result, Write Result
where
Row = the millimeter where calibration occurred
Read Result = results of calibration (R = read, " " = unable to read)
Write Result = results of calibration (W = write, " " = unable to write)
The programming position is indicated in dot rows.