Zenith DTV1080 Using the Remote Control, 3 1 2 4 5 7 8, Zenith Hd Satellite Receiver Operation

4. ZENITH HD SATELLITE RECEIVER OPERATION

4-2. Using the Remote Control

1 POWER

2

MODE

DIRECTV VCR AUX

TV DVD

3 1 2 3

4 5 6

7 8 9

4	0	ENTER 5
MUTE		RATIO
		Pg Up
	VOL	Pg Dn
		CH

SIGNAL FREEZE FLASHBK CC/DATE

MENU GUIDE SURF INFO

HELP EXIT

RECORD STOP L CHAP R CHAP

PAUSE REW PLAY FF

1Power

Turns the HD satellite receiver on and off. If your remote control is programmed to control other components such as VCR, DVD, etc., Power will turn the component on and off. If you want to control other components from different manufacturers, you must first pro- gram your remote control. For further instructions on remote control programming, please refer to the section 4.3 of this operating guide or the Program Remote section of on-screen help.

2Mode

Selects the component that will be controlled by the remote. For example, if your remote control is set to VCR, the CH +/- button will change the channel number of the VCR. If you want to control other components from different manufacturers, you must first program your remote control.

3Digit Buttons (0~9)

Allows you to enter channel numbers for direct tuning or to scroll to the designated page of the program list on the Guide menu. Digit buttons can be used to enter numerical values wherever required e,g, to enter a password.

4Dash (-)

Is used to enter a channel number for multiple program channels such as 2-1, 2-2, etc. A broadcaster may transmit multiple programs on a single channel. Multiple programs are distinguished by a unique sub-channel number, separated by a dash (-).

5Enter ( )

Use with numbered buttons for instant channel selection. When you press a channel number, for example, 22, the receiver awaits anoth- er stroke for three seconds and then tunes to 22.

34

206-3675