4-3. Programming the Remote Control
The HD satellite receiver remote control is a
NOTE
The remote control may not control all models of other brands.
1.Test your remote control
To find out whether your remote control can operate a component without programming, turn on the component such as a VCR and press the corresponding mode button (VCR) on the remote control while pointing at the component. Use the Power and CH +/- buttons to see if the component responds properly. If not, the remote control requires programming.
2.Turn on the component to be programmed. Then press the corresponding mode button on the remote control.
3.Press the Power button and the Mute button simultaneously. The remote control is now ready to program the code for the component.
4.There are two ways to find the right code of the component.
First, if you press the CH +/- buttons repeatedly, the code will change one at a time. Press the Power button after each code change. If the right code is found, the device will turn off.
Second, enter the code number using the digit buttons on the remote control. The right code numbers for the corresponding component can be found on the following pages. Again, if the code is correct, the device will turn off.
5.Press the Exit button to store the programming code.
6.Test the remote control functions to see if the component responds properly. If not, repeat from step 2.
37
