Zenoah G3200EZ manual Operation, Starting the Engine

English

8. Operation

F8-1

(1)

(2)

WARNING

It is very dangerous to run a chainsaw that mounts broken parts or lacks any parts.

Before starting engine, make sure that all the parts including bar and chain are installed properly.

■STARTING THE ENGINE

1.Fill fuel and chain oil tanks respectively, and tighten the caps securely. (F8-1)

F8-2

(1)

F8-3

(1)

F8-4 (1)

(2) (3)

(1)Fuel

(2)Chain oil

2. Set the switch to “I” position. (F8-2)

(1) Switch

3.Continuously push the priming bulb until fuel comes in the bulb. (F8-3)

(1) Priming bulb

4.Pull out the choke knob completely to close the choke. (F8-4)

(1)Choke knob

(2)Close

(3)Open

NOTE

When restarting immediately after stopping the engine, you need not to pull out the choke knob.

F8-5

5. While holding the saw unit securely on the ground, pull the starter rope vigorously. (F8-5)

WARNING

Do not start the engine while the chain saw hangs in one hand. The saw chain may touch your body. This in very dangerous.

28