Zoom 4401, 4420-A Connecting the Hardware

Chapter 1. Installing the AP+4

Turn on the computer.

The WLAN LED continues flashing and the connected LAN port and the ACT (Activity) LEDs become steady on. (If you have a 10 Mbps Ethernet connection, the LAN LED does not turn on.)

If you want the AP+4 to have access to the Internet, connect its WAN port to the Ethernet port on your cable modem, ADSL modem, or other broadband device. When you do this, the WAN LED turns on if the broadband device is on and its Ethernet port is working.

Connecting the Hardware

1 Put the AP+4 near a computer to be used for setup. That computer needs an Ethernet (LAN) port.

2 Turn off the computer.

3 Connect one end of the supplied power cube to the AP+4 PWR jack, and the other end to a live power source.

Important! Only use the power cube shipped with the AP+4. Other power cubes may damage the device.

The PWR LED on the AP+4 front panel should turn on and the WLAN LED should flash. (The WLAN LED continues to flash to signify broadcast activity as long as the Wireless LAN is enabled. It is enabled by default.)

4 Connect one end of the supplied Ethernet cable to the computer’s Ethernet port and the other end to one of the AP+4’s LAN ports.