Chapter 9 - Fax Operation
9-6
Command Value Description
+FDR Receive phase C data command; initiates
document reception.
+FDT=df,vr,wd, ln Transmit phase C data command: release the
DCE to proceed with negotiation.
+FECM=nError mode control:
n=0 Error mode is disabled.
n=2 Error correcting mode is enabled, handled by
the DCE alone, including buffering of partial
pages.
+FET=nEnd of page or document command:
n=0 More pages; same document.
n=1 End of document; another document follows.
n=2 No more pages or documents.
n=4 Procedure interrupt; another page follows.
n=5 Procedure interrupt; end of document, another
document follows.
n=6 Procedure interrupt; end of document.
+FK Regular fax abort command.
+FLID="string" Local ID string parameter.
+FLO=nFlow control options:
n=0 No flow control.
n=1 Set XON/XOFF software flow control.
n=2 Set CTS/RTS hardware flow control.
+FLPL=nDocument for polling command:
n=0 The DTE has no document available for
polling.
n=1 Indicate a document available for polling.
+FMDL? Request DCE model .
+FMFR? Request DCE manufacturer .
+FMINSP=nMinimum phase C speed parameter:
n=0 2400 bps.
n=1 4800 bps.
n=2 7200 bps.
n=3 9600 bps.
n=4 12000 bps.
n=5 14400 bps.
+FPHCTO=
<value> 0-255 DTE Phase C response timeout:
Determine how long the DCE will wait for a
command after reaching the end of data when
transmitting in Phase C.
<value>=0 to 255; 100 ms units.
+FPTS=nPage transfer status