Prestige 652 ADSL Security Router

where “i” specifies binary image transfer mode (use this mode when transferring binary files), “host” is the Prestige IP address, “get” transfers the file source on the Prestige (rom-0, name of the configuration file on the Prestige) to the file destination on the computer and renames it config.rom.

19.2.8 GUI-based TFTP Clients

The following table describes some of the fields that you may see in GUI-based TFTP clients.

 

Table 19-3 General Commands for GUI-based TFTP Clients

 

 

COMMAND

DESCRIPTION

Host

Enter the IP address of the Prestige. 192.168.1.1 is the Prestige’s default IP

 

address when shipped.

Send/Fetch

Use “Send” to upload the file to the Prestige and “Fetch” to back up the file on

 

your computer.

 

 

Local File

Enter the path and name of the firmware file (*.bin extension) or configuration

 

file (*.rom extension) on your computer.

Remote

This is the filename on the Prestige. The filename for the firmware is “ras” and

File

for the configuration file, is “rom-0”.

Binary

Transfer the file in binary mode.

 

 

Abort

Stop transfer of the file.

 

 

Refer to section 19.2.5 to read about configurations that disallow TFTP and FTP from the WAN.

19.2.9 Backup Via Console Port

Back up configuration via console port by following the HyperTerminal procedure shown next. Procedures using other serial communications programs should be similar.

Step 1. Display menu 24.5 and enter “y” at the following screen.

Ready to backup Configuration via Xmodem.

Do you want to continue (y/n):

Figure 19-3 System Maintenance — Backup Configuration

19-6

Firmware and Configuration File Maintenance