Prestige 652 ADSL Security Router

 

 

 

 

 

 

FIELD

DESCRIPTION

EXAMPLE

 

 

Schedule Sets

You can apply up to four schedule sets here. For more details

 

 

 

 

please refer to the Call Schedule Setup chapter.

 

 

 

Nailed up

This field specifies if you want to make the connection to this

 

 

 

Connection

remote node a nailed-up connection. More details are given earlier

 

 

 

 

in this section.

 

 

 

Session Options

Use [SPACE BAR] to choose Yes and press [ENTER] to open

No

 

 

Edit Filter Sets

menu 11.5 to edit the filter sets. See the Remote Node Filter

(default)

 

 

section for more details.

 

 

 

 

 

 

 

Idle Timeout (sec)

Type the number of seconds (0-9999) that can elapse when the

0

 

 

 

Prestige is idle (there is no traffic going to the remote node), before

(default)

 

 

 

the Prestige automatically disconnects the remote node. 0 means

 

 

 

 

that the session will not timeout.

 

 

 

When you have completed this menu, press [ENTER] at the prompt “Press [ENTER] to confirm or [ESC]

 

 

to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.

 

 

 

 

 

 

5.1.3 Outgoing Authentication Protocol

For obvious reasons, you should employ the strongest authentication protocol possible. However, some vendors’ implementation includes specific authentication protocol in the user profile. It will disconnect if the negotiated protocol is different from that in the user profile, even when the negotiated protocol is stronger than specified. If the peer disconnects right after a successful authentication, make sure that you specify the correct authentication protocol when connecting to such an implementation.

5.2Remote Node Setup

For the TCP/IP parameters, perform the following steps to edit Menu 11.3 – Remote Node Network Layer Options as shown next.

Step 1. In menu 11.1, make sure IP is among the protocols in the Route field.

Step 2. Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes, then press [ENTER] to display Menu 11.3 – Remote Node Network Layer Options.

Remote Node Configuration

5-5