Prestige 782R G.SHDSL Router

The following table describes some of the fields that you may see in third-party TFTP clients.

COMMAND

DESCRIPTION

Host

Type your IP address. 192.168.1.1 is the Prestige default IP address when shipped.

 

 

Send/Fetch

Press [Send] to upload the file to the Prestige and [Fetch] to back up the file on your

 

computer.

 

 

Local File

Type the path and firmware file name (*.bin extension) or configuration file (*.rom

 

extension) on your computer.

Remote File

The Prestige filename. The firmware filename is ras. The configuration file, is rom-0.

 

 

Binary

Transfer the file in binary mode.

 

 

Abort

Stop transfer of the file.

 

 

10.7.4 Boot Module Commands

When you reboot your Prestige, you will be given a choice to go into debug mode by pressing a key at the prompt shown in the following screen. In debug mode you have access to a series of boot module commands, for example ATUR (for uploading firmware) and ATLC (for uploading the configuration file) already discussed in a previous section.

Bootbase Version: V2.00 4/14/2001 13:58:03

RAM: Size = 8192 Kbytes

FLASH: Intel 8M *2

ZyNOS Version: V2.50(BH.0)b5 12/12/2001 14:01:55

Press any key to enter debug mode within 3 seconds.

.................................................

Figure 10-19 Option to Enter Debug Mode

Type ATHE to view all available Prestige boot module commands. Some are shown in the next screen. Most commands aid in advanced troubleshooting and should only be used by qualified engineers.

System Maintenance

10-17