Prestige 782R G.SHDSL Router

Menu 11.2 - Remote Node PPP Options

Encapsulation= Standard PPP

Compression= No

Enter here to CONFIRM or ESC to CANCEL:

Press ENTER to Confirm or ESC to Cancel:

Press Space Bar to Toggle.

Figure 4-3 Menu 11.2 – Remote Node PPP Options

The following table describes the Remote Node PPP Options menu and how to configure the PPP options.

Table 4-2 Remote Node PPP Options Menu Fields

FIELD

DESCRIPTION

OPTIONS

Encapsulation

Select Standard PPP. Select CISCO PPP only if

Standard PPP

 

the node is a Cisco computer.

CISCO PPP

 

 

 

 

 

Compression

Turn on/off Stac Compression. The default is No.

Yes/No

 

 

 

When you have completed this menu, press [ENTER] at the prompt “Press [ENTER] to confirm or [ESC] to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.

4.2Remote Node Setup

For the TCP/IP parameters, perform the following steps to edit Menu 11.3 – Remote Node Network Layer Options as shown next.

Step 1. In Menu 11.1, make sure IP is among the protocols in the Route field. The Route field should display IP or IP+IPX.

Step 2. Move the cursor to the Edit IP/IPX/Bridge field, press [SPACE BAR] to toggle and set the value to Yes, then press [ENTER] to display Menu 11.3 Remote Node Network Layer

Options.

Remote Node Configuration

4-5