Prestige 782R G.SHDSL Router

Step 2. Type your new system password (up to 30 characters) and press [ENTER].

Step 3. Re-type your new system password to confirm and press [ENTER]. The screen displays an asterisk “*” for each character you type.

2.8Resetting the Prestige

If you forget your password or cannot access the SMT menu, you need to reinstall the configuration file. Reinstallation replaces the current file with the factory configuration file. All custom configurations will be lost and the console port speed will be reset to the default. (9600 bps with 8 data bit, no parity, 1 stop bit (8n1), and no Flow Control.) The password will be reset to the default of 1234.

Turn off your Prestige and begin a Terminal session with the current console port settings. Turn on your Prestige again. You should see the following screen. When you see the message "Press any key to enter debug mode within 3 seconds", press any key. Make sure you have the configuration file or have already downloaded the latest one from the ZyXEL web site.

Bootbase Version: V2.00 4/14/2000 13:58:03

RAM: Size = 8192 Kbytes

DRAM POST: Testing: 8192K OK

FLASH: Intel 8M *2

ZyNOS Version: V2.50(BH.0)b5 12/12/2000 14:01:55

Press any key to enter debug mode within 3 seconds.

........................................

(Compressed)

Version: P782R STU, start: 0203c030

Length: 149AAO, Checksum: EEB7

Compressed Length: B4140, Checksum: A562

Figure 2-8 Booting Up the Prestige

To upload the configuration file, do the following:

Step 1. Type atlc after the Enter Debug Mode message.

Step 2. Wait for the Starting XMODEM upload message before activating XMODEM upload on your terminal.

Step 3. After a successful firmware upload, type atgo to restart the Prestige.

The Prestige is now reinitialized with a default configuration file including the default password of 1234.

2-8

Hardware Installation and Initial Setup