ZyXEL Communications omni.net LCD series quick start Install Driver and PPP Setup for MacOS

omni.net LCD series Quick Start Guide

6.Install Driver and PPP Setup for

MacOS

This section provides step by step procedures to install the USB driver and set up PPP on MacOS.

Install Driver for MacOS

ZyXEL_USB_Installer, a MindVision VISE Installer, is used to install ZyXEL USB omni.net LCD Plus SUB driver on your Macintosh computer. Follow the instructions below.

Step 1. Be sure your omni.net LCD Plus is on.

Step 2. Insert the BONUS CD attached with your TA device into your CD-ROMdrive. You will see the icon as shown below.

Step 3. Plug the USB connector that is attached to your USB-TA into any one of your computer devices with USB port, (such as your monitor, keyboard, etc).

Note: If you have used the USB connector to connect your USB-TA with another USB device before you have inserted the BONUS CD into your CD-ROM drive, then your computer will show an error message.

Step 4. Double click on the ZyXEL_USB_Installer icon and then click Continue.

6-1