Omni.Net Lite User’s Guide

Note: The high threshold must be greater than the low threshold, otherwise, both of them will be reset to the default.

2.5.4 Configuring PPP/MP Parameters

Click PPP/MP Parameters under RS-232 Port to display the screen as shown next.

Figure 10 RS-232 Port: PPP/MP Parameters

The following table describes the labels in this screen.

Table 6 RS-232 Port: PPP/MP Parameters

LABEL

DESCRIPTION

 

 

Enable Fixed MP

Select this option to combine both B-channels into one PPP link for data calls

(fixed 128K)

and always has the higher transmission rate.

Enable CHAP

Select this option to have your TA use CHAP for link authentication with the

 

username and/or password.

Enable Call Bumping

Select this option to allow bandwidth release for voice calls.

 

 

Maximum throughput

This field is not available if you select Enable Fixed MP.

(1 or 2 B-channel)

Select 64 kbps (1 B-channel)to activate only one B-channel and transmit

 

data at 64 kbps.

 

Select 128 kbps (2 B-channel)if if you want to bundle two B-channels to

 

increase the data transfer rate. This is called multilink.

35

Chapter 2 Using the Utility