Omni.Net Lite User’s Guide

 

Table 14 AT Data Command Sets Requiring an "AT" Prefix

 

 

 

 

 

COMMAND

OPTION

DESCRIPTION

 

 

 

 

 

%D3=n

 

The number of retrying to re-dial the outgoing data call once TA

 

 

 

failed to establish the data call.

 

 

 

n=0: don't re-dial.

 

 

 

n=1~10: re-dial for n times until the call is established.

 

 

 

 

 

%Id=<phone

 

Create a list of the incoming call phone number via the data port.

 

number> [/<sub-

 

d=0-4.

 

address>]

 

 

 

<phone number>: Enter up to 32 characters, including digits

 

 

 

 

 

 

from 0 to 9, *, #, hyphen ( -), comma (,) and (‘,’). [‘,’] will be

 

 

 

ignored.

 

 

 

<sub-address>: Enter up to 20 ASCII characters ranging from

 

 

 

“0-9”,” a-z” and “A-Z”.

 

%M1=n

 

Enable/Disable PAP to CHAP conversion.

 

 

 

n=0: Disable CHAP (default).

 

 

 

n=1: Enable CHAP.

 

 

 

 

 

%M2=n

 

Enable/Disable "Dynamic Bandwidth Allocation for Voice Call".

 

 

 

n=0: Disable.

 

 

 

n=1: Enable (default).

 

 

 

 

 

%M3=n

 

Set threshold of data loading to add one channel, the unit is

 

 

 

kbps.

 

 

 

n=0-64, the default is 35.

 

 

 

 

 

%M4=n

 

Set a threshold of data loading to drop one channel, the unit is

 

 

 

kbps.

 

 

 

n=0-64, the default is 25.

 

 

 

 

 

%M5=n

 

Persist time for monitoring threshold to add or drop one channel,

 

 

 

the unit is 5 seconds.

 

 

 

n=1-255, the default is 24.

 

 

 

 

 

%Od=<prefix digits>

 

Create a list of the outgoing call prefix digits for the data port.

 

 

 

d=0-2.

 

 

 

 

 

%P0=n

 

Set incoming call screen mode for the data port.

 

 

 

n=0: Accept all incoming calls (default).

 

 

 

n=1: Reject all incoming calls.

 

 

 

n=2: Only accept the calls from the phone number in the list (see

 

 

 

%Id=<phone number> [/<sub-address>]).

 

 

 

n=3: Only reject the calls from the phone number in the list (see

 

 

 

%Id=<phone number> [/<sub-address>]).

 

%P1=n

 

Set outgoing call screen mode for the data port.

 

 

 

n=0: No restriction (default).

 

 

 

n=1: Prohibit all outgoing calls.

 

 

 

n=2: Only accept the calls with the prefix in the pre-defined list

 

 

 

(see %Od=<prefix digits>).

 

 

 

n=3: Only reject the calls with the prefix in the pre-defined list

 

 

 

(see %Od=<prefix digits>).

Chapter 3 Using AT Commands

58