Omni.Net Lite User’s Guide

Table 15 AT Command Sets for the Analog Port

COMMAND

DESCRIPTION

 

 

!pS=<phone

Assign you phone number to the analog port.

number> [/<sub-

p: enter 1 or 2 to specify the analog port.

address>]

<phone number>: Enter up to 32 characters, including digits from 0 to 9, *, #,

 

 

hyphen ( -), comma (,) and (‘,’). [‘,’] will be ignored.

 

<sub-address>: Enter up to 20 ASCII characters ranging from “0-9”,” a-z” and

 

“A-Z”.

$D99

Upgrade firmware.

 

 

$C0?

Display the charge information of the last call.

 

Use $C0=0 to clear the information.

$C1?

Display the accumulative charge information of the calls.

 

Use $C0=1 to clear the information.

$F99

Reset all parameters to the factory defaults.

 

 

$P5=<country

Set three-digit country code for caller ID signaling (FSK or DTMF).

selection code>

The default is 216.

 

 

 

3.3.3 Debug Command Sets

The AT command sets for debugging are shown in the following table.

Table 16 Debug Command Sets

COMMAND

DESCRIPTION

 

 

#C0

Clear frame logs.

 

 

#Dn

Display frame logs or internal task status.

 

n=80: display frame logs.

 

n=82: display C/I code (layer 1 signal) logs.

 

 

L6=n

Set the level of frame logs to Q.921.

 

n=0: disable frame logging.

 

n=1: enable signal frame logging.

 

n=2: enable full frame logging.

 

 

L8=n

Set the level of frame logs to V.120, X.75.

 

n=0: disable frame logging.

 

n=1: enable signal frame logging.

 

n=2: enable full frame logging.

 

 

L13=n

Set the level of frame logs to PPP.

 

n=0: disable frame logging.

 

n=1: enable signal frame logging.

 

n=2: enable full frame logging.

 

 

3.4 Configuring Examples with AT Commands

This section shows you some examples of configuring the TA using AT commands.

61

Chapter 3 Using AT Commands