Omni.Net Lite User’s Guide

3.4.8.2 Voice Call

Use AT!pId=<phone number> [/<sub-address>] to configure a list of incoming call phone numbers (with sub-addresses), then use AT!pP0=n to reject or accept the calls with the phone number in the list.

3.4.9 Outgoing Call Screening

Use this function to set restrictions on outgoing calls, such as allowing or prohibiting a long- distance or international call. Refer to Section 3.4.9 on page 65 for more information.

3.4.9.1 Data Call

Use AT%Od=<prefix digits> to configure a list of prefix digits for outgoing calls, then use AT%P1=n to prohibit or allow the calls with the prefix digits in the list.

3.4.9.2 Voice Call

Use AT!pOd=<prefix digits> to configure a list of prefix digits for outgoing calls, then use AT!pP0=n to prohibit or allow the calls with the prefix digits in the list.

Figure 21 AT Command Example 3

3.4.10 Caller ID

Use AT!pA0=n to select the device type to enable call waiting caller ID when you have a call (see Section 3.4.10 on page 65 for more information).

65

Chapter 3 Using AT Commands