ZyXEL Communications Omni.Net Lite 2.12.4.4 Call Transfer

Omni.Net Lite User’s Guide

Figure 18 Analog Port: Supplementary Service

2.12.4.4 Call Transfer

You can transfer a call to a local phone (connected to the TA) or a remote phone (not connected to the TA) through an ISDN line.

2.12.4.4.1Call Transfer between Two Analog Ports

To transfer incoming calls (after you answer this call) to a local phone, follow these steps:

1Press the flash key to put the caller on hold.

2When you hear the dial tone, dial “1#” to operate the Intercom.

3After you hear the ring signal or the second party answer it, press the flash key, then “4”.

4Hang up the phone.

2.12.4.4.2Call Transfer to a Remote Phone

To transfer incoming calls (after you answer this call) to a remote phone, follow these steps:

1Press the flash key to put the caller on hold.

2When you hear the dial tone, simply dial the number you want, to transfer the first call.

3After you hear the ring signal or the second party answer it, press the flash key, then “4”.

Chapter 2 Using the Utility 50